Drivetrain

Pai EM37110 Slave Valve - Same as Mack 21041938

$274.20
Eaton Fuller A7516 Adapter Assembly

$692.83
Eaton Fuller A-7786 Clutch Release Yoke Assy

$278.77
Eaton Fuller K3245 Air Module Assembly

$553.45
Spicer Dana 170-70-18X Universal Joint Strap Kit

$33.05
Meritor CB210661 1XSA Center Bearing

Special Price $110.87 Regular Price $129.25
Pai EM67740 U-Joint

$14.54
S&S Newstar S-26940 Clutch Lube Tube

Special Price $21.14 Regular Price $24.06
Allison 29539579 Transmission Fluid Filter

Special Price $24.89 Regular Price $27.08
Hino 31420E0031 Clutch Master Cylinder

$469.89
Hino 32904-E0120 Tube Assy- Oil Cooler Inlet

$635.57
Hino 212261-1X Center Bearing Assy

Special Price $140.52 Regular Price $152.90
Hino 3350437101C0 Knob Sub-Assy - Shift Lever

$265.46
Hino A11205Z2730 Rear Differential Pinion Seal

$90.73
Hino S314701310 Cylinder Assy - Clutch Release

$204.76
Freightliner 02-12176-000 Pilot Bearing, 72 X 30 X 19MM
Special Price $49.39 Regular Price $65.99
Freightliner 02-13031-001 Clutch Release Stud Shaft
Special Price $45.07 Regular Price $58.99

Items 49-65 of 65

Heavy-Duty Truck Drivetrain Parts

Transfer maximum diesel torque from the flywheel to the drive tires without vibration or power loss. We supply commercial-grade drivetrain components engineered for Eaton Fuller, Meritor, Dana Spicer, and Detroit.

Clutches & Transmission

Heavy-duty 14-inch and 15.5-inch clutch kits, clutch brakes, release forks, and transmission seals built for high-torque manual and automated platforms.

Driveshafts & U-Joints

Heavy-duty universal joints, center carrier bearings, slip yokes, and end yokes designed to eliminate driveline vibration under heavy hauling loads.

Axles & Differentials

Replacement axle shafts, pinion seals, power divider lock components, and differential bearing kits to keep your tandem drive axles running cool.

Tech Tip: Proper U-Joint Greasing & Ride Height

Repeated U-joint failures or sudden driveline vibrations at highway speeds are rarely caused by defective parts. Check these two maintenance items first:

  • Purge All Four Caps: When greasing a serviceable U-joint, pump grease until fresh grease purges from all four bearing cup seals. If one cap refuses to purge, the needle bearings inside are already dry and seized—replace the joint immediately.
  • Verify Rear Ride Height: An out-of-spec rear suspension leveling valve changes the operating angle of the driveshaft. Even a half-inch difference in ride height will cause severe driveline vibration and rapidly destroy U-joints and carrier bearings.
Loading...
loader
Loading...